Description:
Ø Superbright SMD top LED & viewing angle, high brightness output, no spot and shadow.
Ø Colors can be chosen as Full color
Ø Low power consumption & operating voltage, safe and energy-saving.
Ø With IP67 protection rating.
Ø Solid-state, high shock or vibration resistant, long lifetime, more than 50000 hours.
Ø Easy installation with mounting holes and 3M adhesive tape on the back.
ICRGB module with APA106
- individually Control
- Programable & SD controller
- DMX 512 Controllalbe
- Madrix compatible
- IP67, Water-proof protection
- Easy installation (two options: screw fixed, or 3M double side adhesive tape)
Parameter
RGB Pixels are digitally-controllable lights you can set to any color, or animate. Each RGB LED and controller chip is molded into a 'dot' of silicone. The dots are waterproof and rugged. There are four flanges molded in so that you can 'push' them into a 6mm drill hole in any material up to 1.5mm/0.06" thick. They're typically used to make outdoor signs
Each dot is digitally controlled, with an internal 8-bit PWM LED driver (24-bit color for 16 million different shades). The pixels must be clocked by a microcontroller, we have an example code linked below that works on an Arduino, it should be simple to adapt it to any other microcontroller.
The pixels use 5mm diffused RGB LEDs, with a 120 degree beam width. The total max brightness of all LEDs is about 1600mcd but with the light more evenly distributed & mixed than a clear LED
6mm diameter (0.45") 23mm deep (1.5")
100mm
50 pieces per strand
These pixels use a WS2801 chip for full 24 bit color
5V power, 60mA maximum per pixel (LED on full white)
2-pin SPI-like protocol
APA106 the chip inside each pixel
Brightness: Red = 3.3 Lumens/300 mcd, Green = 10 Lumens/1000 mcd, Blue = 2.7 Lumens/300 mcd (mcd calculation based on full 120 degree beam)
|
|
5mm APA106 RGB Full color LED String Images
|
